B24 Speedometer Tone Wheel, 49 Spline, 261HD 261XHD 263HD 263XHD 1998-2007 Silverado/Sierra 2500HD/3500HD LB7/LLY/LBZ Merchant Automotive
B24 Speedometer Tone Wheel, 49 Spline, 261HD 261XHD 263HD 263XHD 1998-2007 Silverado/Sierra 2500HD/3500HD LB7/LLY/LBZ Merchant Automotive
B24 Speedometer Tone Wheel, 49 Spline, 261HD 261XHD 263HD 263XHD 1998-2007 Silverado/Sierra 2500HD/3500HD LB7/LLY/LBZ Merchant Automotive
SKU
25902-FWLR
List price
$29.34
Price
$29.34

    This is a replacement rear output speed sensor tone wheel for GM transfer cases with a 49-spline mainshaft; NP261HD, NP263HD, NP261XHD and NP263XHD.

    The speedometer in your vehicle receives signals created by the speed sensor's magnetic pickup interacting with the peaks and valleys of the tone wheel to accurately indicate vehicle speed. If there is an issue in the speed sensing circuit it can cause the transmission to go into limp mode in an attempt to prevent additional damage.

    FAQ:

    Which direction does the tone wheel face when installing it in the transfer case?

    The tone wheel has a stepped edge on one side, be sure to position the wheel so that the stepped edge faces the transfer case pump.

    Do I need to replace the speed sensor too?

    If the tone wheel was damaged from making contact with the speed sensor both will need to be replaced. Carefully examine the speed sensor to verify if any contact has been made and if there has the sensor should be replaced.

    What fluid should I use in the transfer case and how much is needed?

    We recommend our Performance Transfer Case Fluid for use in ALL transfer cases and have seen improved performance over the factory recommended ATF or other alternate oil recommendations. Two-quarts are required to fill the NP261HD, NP263HD, NP261XHD and NP263XHD transfer cases.

    I hear a grinding noise at low speed after reassembling the transfer case. What could that be?

    A low speed grinding noise is most commonly caused by the rear output bearing snap ring not being fully seated causing the bearing to move out of proper alignment. Verify that the snap ring is fully engaged and properly seated in the rear housing and the locating groove in the bearing.

    What would cause a speed sensor correlation code after reassembling the transfer case?

    A speed sensor correlation code is often accompanied by a low speed grinding noise and is frequently caused by the rear output bearing snap ring not being fully seated causing the bearing to move out of proper alignment. Verify that the snap ring it fully engaged and properly seated in the rear housing and the locating groove in the bearing.

    Details:

    • Engine Manufacturer: Duramax
    • Liter: 6.6 Liter
    • Engine Designation: LB7, LLY, LBZ
    • Engine Years: 1998-2007
    • Transfer Case Model: 261HD, 261XHD, 263HD
    • Spline Count: 49 Spline

    Applications:

    • 1998-2007 Silverado/Sierra 2500HD/3500HD LB7/LLY/LBZ
    CALIFORNIA WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
    Vehicle Fitment
    1999-2004 Chevrolet Silverado 2500
    1999-2004 Chevrolet Silverado 2500 LT
    1999-2004 Chevrolet Silverado 2500 LS
    2001-2005 Chevrolet Silverado 2500 HD
    2001-2007 Chevrolet Silverado 2500 HD LT
    2001-2006 Chevrolet Silverado 3500 LT
    2001-2006 Chevrolet Silverado 3500 LS
    2001-2006 Chevrolet Silverado 2500 HD LS
    2001-2005 Chevrolet Silverado 3500
    2003-2007 Chevrolet Silverado 2500 HD WT
    2004 Chevrolet Silverado 2500 WT
    2004 Chevrolet Silverado 3500 WT
    2006 Chevrolet Silverado 3500 WT
    2007 Chevrolet Silverado 3500 HD LT
    2007 Chevrolet Silverado 2500 HD LTZ
    2007 Chevrolet Silverado 3500 HD LTZ
    2007 Chevrolet Silverado 3500 HD WT
    Liter
    6.6 Liter
    Universal Fitment
    Off
    Brand
    Merchant Automotive
    Category
    Performance
    Speedometer Tone Wheel
    Specs
    Country Of Origin: USA
    Sold As: Each
    UPC: 604947040909
    Availability: Available
    Universal: No
    Fuel Type
    Diesel
    Vehicle Type
    Truck/SUV
    Core Charge
    $0.00
    Engine Manufacturer
    Duramax